Step 1 - Battery Removal
| 1) | To remove the bottom and top cover (ECD Items: M61-3806-15 & M61-3806-20, use a Phillips screw driver to loosen the three screws, 2-56 x 3/16 (ED Item: H00-1003-10). |
.png "<%NOTE#1%>")
| 2) | Carefully turn the M.O.L.E.® EV6 over and remove the top cover. |
|
Be careful not to pull to hard as the overlay label may stick to the display. |
.png "Important Information")
.png "<%NOTE#1%>")
| 3) | Disconnect the battery (ECD ITEM: F30-0060-00). |
.png "<%NOTE#1%>")
Step 2 - Battery Installation
| 1) | Connect the Battery connector into the J5 connector on the Main PCB assembly. Coil excess wire and in the Frame support. |
.png "<%NOTE#1%>")
| 2) | Confirm the Display is working. |
✓Press and hold the ON/OFF button.
✓If the Display does not work please contact ECD Support.
.png "<%NOTE#1%>")
| 3) | Secure the Top and Bottom covers to the Frame. |
✓Insert the Frame in the Bottom cover.
✓Remove the clear protective liner from the Display. With a dust-free cloth, clean the Display to remove any finger prints/smudges and debris.
✓Confirm the Display is properly seated in the Support and the Battery wires are within the Frame support.
✓Place the Top cover on the Frame and secure the covers to the Frame with the three screws, 2-56 x 3/16.
.png "<%NOTE#1%>")